Technical drawings. General principles of presentation - Basic conventions for cuts and sections Ingestion-build-82396 The design of structural products

The design of structural products shall ensure their fitness for the particular application

7 Sampling and sample preparation

ECSS-E-ST-40-07 is a standard based on ECSS-E-ST-40 for the engineering of simulation software

Organizations and schemes using peer assessment

Short-term test with alternate wetting with water and drying in warm air

Technical drawings. General principles of presentation - Basic conventions for cuts and sections Ingestion-build-82396 The design of structural products1 Scope This part of ISO 128 specifies the general principles for presenting cuts and sections applicable to all kinds of technical drawings (mechanical, electrical, architectural, civil engineering, etc.) following the orthographic projection methods specified in ISO 5456 2. For areas on cuts and sections, representation is according to ISO 128 50. Attention has also been given in this part of ISO 128 to the requirements of reproduction, including