Square Tube Die for 302 "One-Shot" Tube and Pipe Bender (32 mm OD, 177.8 mm CLR) NPS 1-1/4

Square Tube Die for 302 "One-Shot" Tube and Pipe Bender (32 mm OD, 177.8 mm CLR) NPS 1-1/4Specs Outside Diameter of the Tubing (OD): 32. 0 mm Minimum Wall Thickness (Mild Steel): 0. 065" (1. 7 mm) Minimum Wall Thickness (Aluminum): Contact for Details Minimum Wall Thickness (Other): Contact for Details Maximum Wall Thickness: 0. 125" (3. 2 mm) Centerline Radius: 7" (177. 8 mm) Maximum Degree of Bend: 90, after springback Includes Steel Main Die Aluminum Follow Bar Steel U Strap Resources Tube and Pipe Bending Basics What Am I Bending: The

Tube and Pipe Bending Basics

start up shop or a small full time fabricator

and Assembled in the USA

This roll set will bend the following sizes of material: 1" x 1" Square

Notice how when values are entered into 2 or 3 directions at one time this is defining angles other than 90 degrees and will also define rotations

Forms quality

Centerline Radius: 2" (50

standard 6 cubic inches of oil/minute on competing models)

SE provides those extra tools that you will need when you are concerned about setup and production times

Roughly 3x faster than our air/hydraulic pumps

Full selection of over 150 dies

SE has extra functionality for roll bending